D7 

D6 

D5 

D4 

D3 

D2 

D1 

D0 

MAVG_INV 

SAIFTTS 

SAIFCTS 

nSGATE 

AISS3 

AISS2 

AISS1 

AISS0 

NAME 

DIRECTION 

DEFAULT 

DESCRIPTION 

X 

- 

- 

Don't Care 

MAVG_INV 

rw 

0 

Invert the state of the moving average filter jumper (M4). This allows one to enable/disable moving average filter through software.
0 = non-inverted or normal operation (default)
1 = invert state of jumper to enable/disable moving average filter function. Observe the state at General Configuration Register. If the M4J bit is set in the General Configuration Register, then the moving average filter is enabled. 

SAIFTTS 

rw 

0 

Sync Analog Input Frame Timer to Trigger Start. If set, then also moves the first sample to just after the trigger start rather than sampling at any time (i.e. 0 to 1 sample interval) after the trigger start.
0 = disabled (default). Timing between samples remains fixed regardless of point of trigger.
1 = Clear Analog Input Frame Timer upon Trigger Start. Sampling begins just after the trigger-start, thus synchronizing the sampling to the trigger start. 

SAIFCTS 

rw 

0 

Sync Analog Input Frame Counter to Trigger Start. This can be used to synchronize sample or frame counting to a trigger start.
0 = disabled (default).
1 = Clear Analog Input Frame Counter upon Trigger Start 

nSGATE 

rw 

0 

Sampling Gate
0 = Ignore triggering subsystem (default)
1 = Use triggering subsystem for ADC-sampling 

AISS[3:0] 

rw 

0000 

Analog Input Sampling Sources. This select the signal that is used to generate ADC-samples or ADC-bursts.
0000 = use ALSS[1:0] configuration (default, legacy ADC-sampling/-burst source)
0001 = Analog Input Sample/Frame Timer.
0010 = Interrupt Threshold Counter
0011 = none
0100 = none
0101 = none
0110 = none
0111 = none
1000 = DIN0 rising edge
1001 = DIN0 falling edge
1010 = DIN1 rising edge
1011 = DIN1 falling edge
1100 = DIN2 rising edge
1101 = DIN2 falling edge
1110 = DIN3 rising edge
1111 = DIN3 falling edge